TwinTurbo.NET: Nissan 300ZX forum - Re: How Much Cerakote?
People Seeking Info
 
   


     
Subject Re: How Much Cerakote?
     
Posted by induetime on October 29, 2024 at 1:04 PM
  This message has been viewed 64 times.
     
In Reply To How Much Cerakote? posted by Lanks on October 24, 2024 at 07:41 PM
     
Message I'm local in Phoenix, AZ as well.

https://zircotec.com/ is the best. Swain is the 2nd best.
Better than both, is not an applied coating, but rather an Inconel heat shielding.
If you are not road racing it's not worth it. For normal & spirited driving driving, coating is fine to help reduce temps. I woudl 100% still use the stock manifold heat shields.

I have not personally used AZ Custom Coatings, but I have heard good things about them.

I use KingPin Coatings (Formally Element Coats). I believe many/most of the local Import tubular manifold companies use KingPin (Future Fab, JDL, Full-Race, etc).

On the couple of tubular manifolds I have made, the Cerakote is still holding up perfectly. I did heat dissipation on my EFR compressor covers as well. I sold that setup some time ago though.

I only have one picture of a down pipe with a coating on it:
https://www.facebook.com/photo/?fbid=2936989213080389&set=a.430067867105882

~Induetime~ "Lag Less"
First Stock Turbo to break 500WHP on boost alone (Pre-E85).
New track car project "Diseaze":
http://arizonazproject.wordpress DOT com
Custom fabrication for the Z32: search QFAB on
Facebook:
HREF="https://www.facebook.com/QFABrication/?fref=ts">La-Z-
Link

More custom fabrication: search FuturFabrication on Facebook:
HREF="https://www.facebook.com/FutureFabrication/?fref=ts">La-Z-
Link

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.