TwinTurbo.NET: Nissan 300ZX forum - Mine looked fine too when installed in 2017. Will be going
Subject
Mine looked fine too when installed in 2017. Will be going
Posted by
itsa300zx
on April 23, 2024 at 9:38 AM
This message has been viewed
122
times.
In Reply To
That's the one I'm running as well. Mine looked "ok" when
posted by Inzane
on April 22, 2024 at 11:41 AM
Message
back to OEM next transmission removal.
Follow Ups
Is this a common failure for an aluminum flywheel?
-
just4kinks
21:20:25 04/20/24
Old school RPS/SZ flywheel?I have the same one
-
itsa300zx
11:43:53 04/21/24
That's the one I'm running as well. Mine looked "ok" when
-
Inzane
11:41:53 04/22/24
Mine looked fine too when installed in 2017. Will be going -
itsa300zx
09:38:06 04/23/24
same thing happened to my Red RPS flywheel in 2016, issues..
-
Halo TTZ
13:48:42 04/21/24
Thanks for the responses, yep it's RPS.
-
just4kinks
16:11:16 04/21/24
They are kinda end of life unless SZ will make new inserts.
-
Bernie (NoVA)
17:38:29 04/21/24
Just dealt with this... Inserts are NLA according to SZ. (n/m)
-
KevinsFairlady
09:02:41 04/25/24
I had nothing but problems with my RPS
-
outkaZTT
09:21:02 04/22/24
The Original ConVerTT has had a red RPS since 2005
-
ConVerTT
12:49:12 04/26/24
Re: Is this a common failure for an aluminum flywheel?
-
VinZmax
11:58:14 04/23/24
Probably similar, but I didn't weigh it. (n/m)
-
just4kinks
14:16:07 04/23/24
I've seen that failure before on a local car.
-
MixManMash
19:22:18 04/27/24
Post a
Followup
You cannot reply to this message because you are not
logged in
.