Subject	Is this a common failure for an aluminum flywheel?
Posted by	just4kinks on April 20, 2024 at 9:20 PM
	This message has been viewed 635 times.
Message	All the screws holding the ring gear backed out, until the ring gear was loose and the engine wouldn't start. Flywheel was installed about 15k miles / 10 years ago. Not a cheap flywheel. Interestingly the screws holding the insert plates were mostly still tight, except for two. Maybe because they were threaded directly into aluminum rather than helicoils. I think I'm done with aluminum flywheels. I replaced this one with chromoly from Action Clutch, it's one-piece and looks nicely made. In case you're wondering what it sounds like when a screw comes loose: La-Z-Link
Follow Ups	Is this a common failure for an aluminum flywheel? - just4kinks 21:20:25 04/20/24 Old school RPS/SZ flywheel?I have the same one - itsa300zx 11:43:53 04/21/24 That's the one I'm running as well. Mine looked "ok" when - Inzane 11:41:53 04/22/24 Mine looked fine too when installed in 2017. Will be going - itsa300zx 09:38:06 04/23/24 same thing happened to my Red RPS flywheel in 2016, issues.. - Halo TTZ 13:48:42 04/21/24 Thanks for the responses, yep it's RPS. - just4kinks 16:11:16 04/21/24 They are kinda end of life unless SZ will make new inserts. - Bernie (NoVA) 17:38:29 04/21/24 Just dealt with this... Inserts are NLA according to SZ. (n/m) - KevinsFairlady 09:02:41 04/25/24 I had nothing but problems with my RPS - outkaZTT 09:21:02 04/22/24 The Original ConVerTT has had a red RPS since 2005 - ConVerTT 12:49:12 04/26/24 Re: Is this a common failure for an aluminum flywheel? - VinZmax 11:58:14 04/23/24 Probably similar, but I didn't weigh it. (n/m) - just4kinks 14:16:07 04/23/24 I've seen that failure before on a local car. - MixManMash 19:22:18 04/27/24
Post a Followup	You cannot reply to this message because you are not logged in.