TwinTurbo.NET: Nissan 300ZX forum - I designed and 3D printed one out of TPU about 4 years ago
Subject
I designed and 3D printed one out of TPU about 4 years ago
Posted by
sdhsbaseball
on September 13, 2023 at 10:29 PM
This message has been viewed
109
times.
In Reply To
Is this rubber boot necessary?
posted by Ted (92TT)
on September 02, 2023 at 09:09 PM
Message
and has been holding great since. No melting or any issues being super close to the exhaust housing of the turbos.
Follow Ups
Is this rubber boot necessary?
-
Ted (92TT)
21:09:35 09/02/23
I have seen a number of these torn.
-
ZXoltan
08:57:37 09/03/23
Yeah, service manual shows it in place but no number ref (n/m)
-
Ted (92TT)
13:48:39 09/03/23
The yellow object is a concern...
-
Denis
11:29:18 09/03/23
That's what I had thought, but it's soft like silicone...
-
Ted (92TT)
13:47:36 09/03/23
I designed and 3D printed one out of TPU about 4 years ago -
sdhsbaseball
22:29:56 09/13/23
Post a
Followup
You cannot reply to this message because you are not
logged in
.