Subject	Ceramic coating (jet hot)
Posted by	JMartz on August 22, 2023 at 2:00 PM
	This message has been viewed 221 times.
In Reply To	Jet Hot: C. Coating / MSP, DP’s, heat shield & turbos posted by Mike@ZSpeed on August 22, 2023 at 12:11 PM
Message	The day my motor comes out, I won't put it back w/o coating the manifolds and turbo exhaust impeller housings. Not so much fot heat control; but for appearance. A rusty surface just doesn't look good. I did the SS headers (with rustable steel flanges) on an Ls pojecc. To my disappointment, in a short time, the flanges started to show rust; but no way near bare.
Follow Ups	Jet Hot: C. Coating / MSP, DP’s, heat shield & turbos - Mike@ZSpeed 12:11:31 08/22/23 Ceramic coating (jet hot) - JMartz 14:00:48 08/22/23 Did you notice any heat reduction under hood? (n/m) - Mike@ZSpeed 14:28:53 08/22/23 This was an engie swap project (Ls in a Solstice) - JMartz 16:08:32 08/22/23 No more "current", but in 2011 when we did the header on our - J-Mart 05:22:53 08/24/23 There is Swaincoat, then there is everything else - LJZTT 17:51:28 08/26/23 I would look at Heatshield Products offerings, they are very - LJZTT 17:55:56 08/26/23
Post a Followup	You cannot reply to this message because you are not logged in.