Subject	Unbolt the master, leave the lines connected. Move it up and
Posted by	Bernie (NoVA) on December 09, 2022 at 2:52 PM
	This message has been viewed 219 times.
In Reply To	quick FUCA bracket question.... posted by VinZmax on December 09, 2022 at 01:45 PM
Message	out of the way. You can wiggle out the brackets without removing the master off the car or having to bleed the brakes. https://www.yugobernie.com/camber.html Install guide is included. Bernie Bilski berniebilski@cox.net President of Z-Car Club of Northern Virginia 1995 Nissan 300ZX TwinTurbo in Cobalt Green 1997 Nissan 240SX SE in Ultra Red 2006 Nissan Frontier SE in Ultra Black
Follow Ups	quick FUCA bracket question.... - VinZmax 13:45:11 12/09/22 Just move the master cylinder. It's two nuts. (n/m) - Zeus 14:03:39 12/09/22 Correct, just have to move it out of the way a bit, not - Barry (NJ) 14:21:33 12/09/22 Re: Just move the master cylinder. It's two nuts. - VinZmax 14:22:53 12/09/22 Re: Re: Just move the master cylinder. It's two nuts. - VinZmax 14:50:59 12/09/22 Unbolt the master, leave the lines connected. Move it up and - Bernie (NoVA) 14:52:17 12/09/22 Re: Unbolt the master, leave the lines connected. Move it up and - VinZmax 15:20:38 12/09/22
Post a Followup	You cannot reply to this message because you are not logged in.