Subject	Re: Use a Helicoil thread insert...
Posted by	devsdead Z32 on June 12, 2022 at 4:47 PM
	This message has been viewed 249 times.
In Reply To	Use a Helicoil thread insert... posted by Denis on June 12, 2022 at 04:30 PM
Message	Okay thank you! Pulling the motor to replace HG's, found this bolt wasn't tight at all when pulling vac hoses & wiring. So took off the manifold to fix threads. since the best spot to hook the motor to pull is off the manifold correct? also thanks for the link! my dad picked up a m12 1.25 insert from his work but figured it was way to big.
Follow Ups	intake manifold bolt took some threads w/ it! help - devsdead Z32 14:52:19 06/12/22 Use a Helicoil thread insert... - Denis 16:30:16 06/12/22 Re: Use a Helicoil thread insert... - devsdead Z32 16:47:04 06/12/22 Thread insert... - Denis 18:14:09 06/12/22 sounds good! thank you for the help! (n/m) - devsdead Z32 19:11:21 06/12/22 Re: intake manifold bolt took some threads w/ it! help - Rob260 05:53:05 06/13/22 Do them all while you' have the lower intake exposed - megaDan 09:36:48 06/13/22 I would replace what is damaged and use a torque wrench to - Bernie (NoVA) 13:52:21 06/13/22 Will do Bernie (n/m) - devsdead Z32 16:44:19 06/13/22 Amen to that... - Denis 17:11:26 06/13/22 That's a good process. (n/m) - Bernie (NoVA) 17:32:52 06/13/22 Many times the problem is owners fail to use the - CmyZ 16:18:39 06/14/22 If you Helicoil it, you should ensure it is drilled square - LitlElvis 12:52:47 06/13/22
Post a Followup	You cannot reply to this message because you are not logged in.