Subject	A poor design from factory requiring a bowstring tight belt
Posted by	BlackholeZ on June 10, 2022 at 5:58 PM
	This message has been viewed 200 times.
In Reply To	You are inventing solutions to non problems (n/m) posted by Bernie (NoVA) on June 10, 2022 at 12:25 PM
Message	is a problem. Yes you can get the factory pulley to not squeak. But it has to be way tighter than it should be because of the insufficient engagement. -Dan "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Pulley opinions - MyBlueZ 16:48:19 06/09/22 Got squeal ? - Mike@ZSpeed 16:56:12 06/09/22 Never heard the engine run - MyBlueZ 17:42:27 06/09/22 Yeah it bugs the hell out of me. - BlackholeZ 19:23:14 06/09/22 If you are really having this much prob. run the stock crank (n/m) - Bernie (NoVA) 20:19:44 06/09/22 I do think I'm going to be getting an ATI damper - BlackholeZ 11:02:28 06/10/22 You are inventing solutions to non problems (n/m) - Bernie (NoVA) 12:25:49 06/10/22 A poor design from factory requiring a bowstring tight belt - BlackholeZ 17:58:31 06/10/22 I disagree on your opinion of "too tight" - Bernie (NoVA) 09:53:12 06/11/22 Efans are crap on these cars and that's a lot of effort - Bernie (NoVA) 09:59:24 06/10/22 Efans are crap when you just strap on a fan - BlackholeZ 10:59:58 06/10/22 Agreed (n/m) - Ghoztt (MD) 11:57:51 06/10/22 You can use the NA crank and NA ps pump w. NA pulley (n/m) - Bernie (NoVA) 17:39:48 06/09/22 Thanks Bernie (n/m) - MyBlueZ 17:41:08 06/09/22 You asked for opinion so here's mine - ZaXxon 07:07:22 06/10/22 Re: You asked for opinion so here's mine - Drk93TT 07:26:48 06/10/22 If you take some 400~800 grit sandpaper and rough up - Ghoztt (MD) 11:37:35 06/10/22 Re: If you take some 400~800 grit sandpaper and rough up - Drk93TT 12:14:24 06/10/22 Thank you (n/m) - MyBlueZ 12:36:16 06/10/22 Meh. They are hit or miss depending on the car/engine. - Ghoztt (MD) 11:34:21 06/10/22 Thank you (n/m) - MyBlueZ 12:37:55 06/10/22 Thanks -- appreciate the opinion (n/m) - MyBlueZ 12:35:44 06/10/22 Re: Pulley opinions - jzack (Mn) 07:48:00 06/12/22 Re: Pulley opinions - MyBlueZ 10:16:29 06/12/22
Post a Followup	You cannot reply to this message because you are not logged in.