Subject	Porting Vs +1mm Valves
Posted by	666whptt on June 08, 2022 at 12:47 PM
	This message has been viewed 287 times.
Message	I’ve searched with no luck, is there any flow data on ported heads with stock valves vs stock ports with +1mm valves?
Follow Ups	Porting Vs +1mm Valves - 666whptt 12:47:14 06/08/22 There are some archived bits of info of builds w/ built - Ghoztt (MD) 14:07:11 06/08/22 Re: There are some archived bits of info of builds w/ built - 666whptt 17:03:24 06/08/22 You will get little out of any one of those independently - ZXoltan 11:16:07 06/09/22 add adjustable cam gears to optimize the new cams - vorpalZed 11:30:51 06/09/22 Yes, if getting cams, adjustable cam gears are a must. (n/m) - Ghoztt (MD) 11:33:09 06/09/22 Ok - Your power goal would determine what best fits your - Ghoztt (MD) 11:27:14 06/09/22 Re: There are some archived bits of info of builds w/ built - 666whptt 10:30:22 06/09/22 Bigger turbos will net you the most in terms of peak - MixManMash 12:36:46 06/09/22 Not directly answering your question but..... - ZaXxon 07:05:34 06/10/22 What did you lay down on pump? (n/m) - Ghoztt (MD) 11:23:35 06/10/22 Can't recall but I believe it was around 550-ish (n/m) - ZaXxon 07:46:53 06/13/22 Re: Re: There are some archived bits of info of builds w/ built - induetime 08:06:24 06/13/22
Post a Followup	You cannot reply to this message because you are not logged in.