Subject	Here's one I did, I can take pics of mine when I get home.
Posted by	Musashi Sword on May 16, 2022 at 3:17 PM
	This message has been viewed 192 times.
In Reply To	Pics. or it didn’t happen posted by Mike@ZSpeed on May 16, 2022 at 12:47 PM
Message
Follow Ups	Does anyone have a instruction manual for MB Quart Speakers - ChrisZTT(Sacto, CA) 23:05:21 05/15/22 If you can't get them to fit in the kick panels you could - Musashi Sword 05:42:02 05/16/22 2nd - vorpalZed 09:39:14 05/17/22 one other question - ChrisZTT(Sacto, CA) 15:39:14 05/17/22 I believe the second pair of inputs is for bi-wiring. You - Inzane 22:02:15 05/17/22 Those are for inputs coming from two different amps. One - Musashi Sword 05:54:08 05/18/22 You would move that jumper pin that says biwire to - Musashi Sword 05:56:06 05/18/22 I love the knowledge on this forum. Thanks all! (n/m) - ChrisZTT(Sacto, CA) 20:21:06 05/18/22 MB quart owner here - Mike@ZSpeed 06:45:10 05/16/22 This is why I put my tweeters in the air vents... (n/m) - Musashi Sword 12:27:48 05/16/22 Pics. or it didn’t happen - Mike@ZSpeed 12:47:51 05/16/22 I've done it in about six Z's. I use a piece of plumbers - Musashi Sword 15:01:31 05/16/22 Here's one I did, I can take pics of mine when I get home. - Musashi Sword 15:17:47 05/16/22 I found some pics of when I put mine together. I used a heat - Musashi Sword 05:51:14 05/17/22 2nd, too much; Exhaust. Intake, Road, etc. noise, to worry - Barry (NJ) 14:57:19 05/16/22 The reason I picked them was because I'm trying to fill a - ChrisZTT(Sacto, CA) 15:19:09 05/17/22 That's quite reasonable. (n/m) - Barry (NJ) 16:00:58 05/17/22 They all wire pretty much the same.... - Madhatter10-6 08:58:32 05/16/22 This is all I could find in my clutter. Hope it helps: - Inzane 10:59:54 05/17/22 I havent seen that brand since the '90s (n/m) - ForceFedTT 16:54:04 05/17/22 I have had these in a box since ~2005. Maybe someday... (n/m) - J-Mart 05:57:37 05/18/22 That's probably about when I bought this set. (n/m) - ChrisZTT(Sacto, CA) 20:18:10 05/18/22
Post a Followup	You cannot reply to this message because you are not logged in.