Subject	clean area on wing, apply dry.
Posted by	vorpalZed on February 17, 2022 at 4:02 PM
	This message has been viewed 231 times.
In Reply To	Question for those who have installed a OEM spoiler stripe. posted by KevinsFairlady on February 17, 2022 at 03:56 PM
Message	carefully smooth out air bubbles before pressing it down firmly. I started from the center under the brakelight and worked out to each end peeling off the backing layer bit by bit as I went and eying the strip alignment to the underside of the wing. It was tedious.
Follow Ups	Question for those who have installed a OEM spoiler stripe. - KevinsFairlady 15:56:00 02/17/22 clean area on wing, apply dry. - vorpalZed 16:02:20 02/17/22 Did you consider a wet method? Or is that a no no? (n/m) - KevinsFairlady 16:08:38 02/17/22 I applied it dry, didn't try wet... dunno if it would mess - vorpalZed 17:07:07 02/17/22 Thank you. Hoping wet is an option, to make things easier. (n/m) - KevinsFairlady 17:38:08 02/17/22 I only applied 1, but applied it wet via soapy water - ZXRider 17:56:21 02/17/22 Good news! Thank you... (n/m) - KevinsFairlady 09:48:06 02/18/22 2nd, soapy water works great (n/m) - Ted (92TT) 01:13:37 02/18/22 Thank you as well! (n/m) - KevinsFairlady 09:48:34 02/18/22 Re: Question for those who have installed a OEM spoiler stripe. - Z DNA 17:21:11 02/17/22 I went with Z1 because I needed a couple other things... (n/m) - KevinsFairlady 17:37:05 02/17/22 Doesn't answer your question but - Drk93TT 18:53:51 02/17/22 Re: Doesn't answer your question but - NashNative 19:31:25 02/17/22 Agreed... - KevinsFairlady 09:52:02 02/18/22 I considered that... - KevinsFairlady 09:50:02 02/18/22 Did you get the old sticker off yet? (n/m) - Mike@ZSpeed 21:01:01 02/17/22 Never had one... It's an aftermarket spoiler. (n/m) - KevinsFairlady 09:52:41 02/18/22 Consider yourself lucky. - Mike@ZSpeed 16:10:37 02/19/22 I actually used black 1080 3M and knifeless tape wet - ConVerTT 14:33:44 02/18/22 Not a bad alternative... Love the innovation! (n/m) - KevinsFairlady 20:28:09 02/18/22 Thanks! (n/m) - ConVerTT 13:00:26 02/22/22
Post a Followup	You cannot reply to this message because you are not logged in.