|
|
|
|
|
|
Subject |
Re: I have 245/40/18 fronts with a +37 offset, but no rubbing... |
|
|
|
|
Posted by |
YamilZ32 on February 15, 2022 at 11:04 AM |
|
|
This message has been viewed 215 times. |
|
|
|
|
In Reply To |
I have 245/40/18 fronts with a +37 offset, but no rubbing... posted by KevinsFairlady on February 15, 2022 at 10:11 AM |
|
|
|
|
Message |
Thanks so much for your input. I have +30 in front, vs +37 in your case. May be is that, may be is my suspension config. In comparison with the picture you posted here, I´d say that it similar to yours or a little bit higher in the front. Yes, rubbing is not that much, but enough to make a hole in the plastic guard. I appreciate the heat gun option, I was not aware of that as an option and this material to be able to proceed. The only option I ve considered is to have a new hole in the fender and clip with an OEM push in clip into to the chassis. Problem was how to have a new place/hole to clip it, and ot be honest, not a fun of soldering or drilling something there to have the clip room. Uglier than not having the fender, I´d say. Will hear to see if any other approach suggested, however will be very considered. Thanks again.
|
|
|
|
|
Follow Ups |
|
|
|
|
|
Post a Followup |
You cannot reply to this message because you are not logged in.
|
|
|
|
|
|
|
|
|