Subject	Could you please direct me on the specific de-pin tool?
Posted by	ZXRider on January 12, 2022 at 3:27 PM
	This message has been viewed 285 times.
In Reply To	Thx... waiting on an 0.8mm tool, everything I have is posted by Gordo LSZ Daytona on January 10, 2022 at 11:48 AM
Message	I always use small precision screw drivers/dental picks but much rather have the specific tool.
Follow Ups	Bulb Warning Light comes on w/ exterior lights - Gordo LSZ Daytona 16:26:35 01/06/22 Tech not General - FrozTTy 07:56:10 01/07/22 The bulb is inside the cluster. (n/m) - Bernie (NoVA) 12:34:34 01/07/22 Thx Bernie. That's what I wanted to know. (n/m) - Gordo LSZ Daytona 13:02:54 01/07/22 Re: Thx Bernie. That's what I wanted to know. - Drk93TT 19:26:43 01/07/22 Wires going into left side of cluster.... which one to cut? - Gordo LSZ Daytona 16:48:34 01/07/22 You will only need to depin 1 to break the circuit (n/m) - Bernie (NoVA) 11:27:14 01/10/22 Thx... waiting on an 0.8mm tool, everything I have is - Gordo LSZ Daytona 11:48:19 01/10/22 Could you please direct me on the specific de-pin tool? - ZXRider 15:27:47 01/12/22 I have a cheap set of these that has worked well for me - itsa300zx 16:05:31 01/13/22 I also have a couple of circular depinning tools, no doubles (n/m) - Gordo LSZ Daytona 12:38:21 01/14/22 Keenso Terminal Tools, 5pcs/1 Set - Gordo LSZ Daytona 12:26:52 01/14/22
Post a Followup	You cannot reply to this message because you are not logged in.