TwinTurbo.NET: Nissan 300ZX forum - Studs for the entire plenum is an interesting idea
Subject
Studs for the entire plenum is an interesting idea
Posted by
Lumpydonut
on September 06, 2021 at 3:34 PM
This message has been viewed
159
times.
In Reply To
There’s a lot of things nissan did that were questionable..
posted by Stanky (BC)
on September 06, 2021 at 01:31 PM
Message
Would make lining everything up so much easier... I might have to give that a try
Follow Ups
Why didn't Nissan just use 5 studs on the balance tube?
-
Lumpydonut
14:03:43 09/05/21
Never ask why when working on a Z.
-
jmw300zx
15:02:23 09/05/21
…. CAD (n/m)
-
Mike@ZSpeed
17:45:20 09/05/21
There’s a lot of things nissan did that were questionable..
-
Stanky (BC)
13:31:36 09/06/21
Studs for the entire plenum is an interesting idea -
Lumpydonut
15:34:18 09/06/21
ABS in car is fine. It helps protect it. PTU is fine too.
-
Bernie (NoVA)
20:48:47 09/06/21
You can't service that without pulling the side idle tube... (n/m)
-
Bernie (NoVA)
20:47:31 09/06/21
Studs were used on the through-holes so they could be sealed
-
LitlElvis
11:42:44 09/07/21
Post a
Followup
You cannot reply to this message because you are not
logged in
.