TwinTurbo.NET: Nissan 300ZX forum - Yes, I guess I could lift and set my 4" solid concrete
Subject
Yes, I guess I could lift and set my 4" solid concrete
Posted by
not4resaleZ
on August 22, 2021 at 2:50 PM
This message has been viewed
191
times.
In Reply To
get the new TL, you should have plenty of room to wrench
posted by moxie (SF)
on August 22, 2021 at 01:10 PM
Message
blocks under the wheels, lower and use the truck blocks to get it about as high as I would want. Costco and Home Depot seem to have had great prices in the past. I'll wait and see if they have any deals on the 5000TL between now and spring.
Follow Ups
For you folks that use quickjacks
-
moxie (SF)
10:17:18 08/19/21
I have the BL-7000SLX. Fits under my Z fine (n/m)
-
itsa300zx
10:50:38 08/19/21
you da man! TY!
-
moxie (SF)
11:10:02 08/19/21
How much higher? Make sure it will fit between the F/R tires
-
itsa300zx
11:38:39 08/19/21
Re: How much higher? Make sure it will fit between the F/R tires
-
moxie (SF)
13:31:19 08/19/21
Good to know
-
BlackholeZ
13:01:41 08/19/21
The SLX models may be too short for your Cayenne, however
-
not4resaleZ
22:16:05 08/19/21
oh, i see, it's the slx vs ext. I get it now
-
moxie (SF)
23:53:53 08/19/21
Thanks for the info, good points
-
BlackholeZ
13:18:45 08/20/21
I would get the standard TL
-
moxie (SF)
22:42:55 09/02/21
Thank you! Looking into these as well... Good info! (n/m)
-
KevinsFairlady
18:28:01 08/19/21
Did you know the bottom point of the crest is
-
FrozTTy
14:24:04 08/19/21
Anyone know if the 5000tl would allow for transmission
-
not4resaleZ
12:31:31 08/21/21
Re: Anyone know if the 5000tl would allow for transmission
-
megaDan
22:18:22 08/21/21
get the new TL, you should have plenty of room to wrench
-
moxie (SF)
13:10:24 08/22/21
Yes, I guess I could lift and set my 4" solid concrete -
not4resaleZ
14:50:34 08/22/21
I can (and have many times), dropped my transmission
-
moxie (SF)
22:45:00 09/02/21
Why is it not listed on their website.
-
mrchips
08:05:24 08/29/21
Because they want to sell out of their old models first
-
moxie (SF)
14:33:01 09/02/21
Post a
Followup
You cannot reply to this message because you are not
logged in
.