TwinTurbo.NET: Nissan 300ZX forum - Maybe - eventually surface rust popped on the tubes (n/m)
Subject
Maybe - eventually surface rust popped on the tubes (n/m)
Posted by
Bernie (NoVA)
on April 15, 2021 at 6:58 PM
This message has been viewed
179
times.
In Reply To
That likely had more to do with the coating not being
posted by BlackholeZ
on April 15, 2021 at 05:03 PM
Message
Follow Ups
Average/ approximate cost for ceramic coating manifolds?
-
ZXoltan
19:23:56 04/10/21
I spent $325 to cerakote the long tube headers on my swap.
-
Gordo LSZ Daytona
20:12:44 04/10/21
Jet Hot quoted me ~400 sorta recently. (n/m)
-
Bernie (NoVA)
22:18:32 04/10/21
My quote was from last June. Maybe the price dropped?
-
ZXoltan
08:18:10 04/11/21
Well the last time I sent something to Jet Hot was 2005, I
-
Bernie (NoVA)
09:37:42 04/11/21
Yeah, I hear ya'. Their prices have more than doubled since
-
robo (sebring1970)
12:05:55 04/11/21
I should have mentioned, I always did their metallic
-
robo (sebring1970)
14:28:16 04/14/21
The sterling coating would burn through on DPs. it ran too
-
Bernie (NoVA)
15:04:00 04/14/21
The Jet Hot Sterling coating was rated for temperatures
-
robo (sebring1970)
16:40:54 04/14/21
Your 92 has 3 inch stainless when it crashed.
-
Bernie (NoVA)
23:38:35 04/14/21
This is good insight. Thanks for sharing. (n/m)
-
Zeus
13:21:19 04/15/21
Now he tells me <insert rolls eyes emoji> jaja (n/m)
-
robo (sebring1970)
08:17:26 04/18/21
This was one example....
-
Bernie (NoVA)
00:03:23 04/15/21
That likely had more to do with the coating not being
-
BlackholeZ
17:03:42 04/15/21
Maybe - eventually surface rust popped on the tubes (n/m) -
Bernie (NoVA)
18:58:24 04/15/21
Yeah I did see a few spots near the welds in the middle (n/m)
-
BlackholeZ
11:44:40 04/16/21
$300 for Swain...
-
ElectroZ
12:46:45 04/15/21
Per side or for the pair? I thought it was each side. (n/m)
-
ZXoltan
13:49:57 04/15/21
Re: Per side or for the pair? I thought it was each side.
-
ElectroZ
11:31:52 04/16/21
OK Interesting--thanks.
-
ZXoltan
15:40:41 04/16/21
Re: Average/ approximate cost for ceramic coating manifolds?
-
DanielThomas
16:15:18 04/15/21
Post a
Followup
You cannot reply to this message because you are not
logged in
.