TwinTurbo.NET: Nissan 300ZX forum - Nice, thanks! Was using a few torque wrenches...
People Seeking Info
 
   


     
Subject Nice, thanks! Was using a few torque wrenches...
     
Posted by mysticLegoZ on February 25, 2021 at 2:07 PM
  This message has been viewed 119 times.
     
In Reply To Calibration is easy with dead weight method using a known>> posted by ZUL8TR on February 25, 2021 at 04:03 AM
     
Message Think one capped out at ~120, and another at ~250...

Thankfully, had the common sense to release the load, and reset before storing it away...

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.