Subject	I don't suspect that'll be an issue
Posted by	Zeus on February 16, 2021 at 2:02 PM
	This message has been viewed 328 times.
In Reply To	Question re: Specialty Z intake pipes posted by Buckaroo Banzai on February 16, 2021 at 12:21 PM
Message	It'll certainly be tighter than the oem pipe given the added diameter, but you should still be able to reach the two back bolts with a couple of swivels. If you're really concerned, just install the headlamps first? Here's a reference shot of my SZ intake piping on the driver side. Not the best pic, but I'd feel confident getting to that back headlamp bolt. and yes...I know the recirc is touching the oil cooler.... Zeus
Follow Ups	Question re: Specialty Z intake pipes - Buckaroo Banzai 12:21:06 02/16/21 I just did this with the headlamps and rad in place. - itsa300zx 13:37:42 02/16/21 Re: I just did this with the headlamps and rad in place. - Buckaroo Banzai 15:00:48 02/16/21 Do you have the low profile engine mounts? - itsa300zx 15:38:33 02/16/21 Re: Do you have the low profile engine mounts? - Buckaroo Banzai 21:35:16 02/16/21 You'll be fine. That's how I did it. (n/m) - ZaXxon 13:38:52 02/16/21 Re: You'll be fine. That's how I did it. - Buckaroo Banzai 15:01:54 02/16/21 First drive after upgrades, no issues re-installing anything - ZaXxon 07:33:20 02/17/21 I don't suspect that'll be an issue - Zeus 14:02:01 02/16/21 Re: I don't suspect that'll be an issue - Buckaroo Banzai 15:03:50 02/16/21 You could try mocking it up first - Zeus 15:09:03 02/16/21 Swivel sockets or Swivel wrenches - ZXRider 11:47:30 02/17/21
Post a Followup	You cannot reply to this message because you are not logged in.