| Message |
The pins are already double sealed at the back of the connector, and the connector seals the front when plugged in. Main thing that does is strain relieve the wires. If this was something that was being handled of flexed regularly, it'd definitely be a good idea. Or if it was to be mounted in a fender well where frequent direct water splashing was expected it'd further help keep water out.
Since it's mounted out of the way of water/spray even under pretty torrential conditions and essentially stays fixed in place, it's probably an unnecessary cost and labor addition for Brett that won't improve things for the user much.
-Dan
 "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse."
"'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr
"full alphabetic boost mode" -
ChristopherTheOne
" Purrs like a sexually satisfied black panther." - BigTDogg
"Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines |
 |
