TwinTurbo.NET: Nissan 300ZX forum - Re: Not necessary in any way?
Subject
Re: Not necessary in any way?
Posted by
SRH
on December 12, 2020 at 1:06 AM
This message has been viewed
175
times.
In Reply To
Not necessary in any way?
posted by robo (sebring1970)
on December 11, 2020 at 05:34 AM
Message
I was referring to the hinge covers as not being necessary. I agree, the cowl covers are a must.
Follow Ups
Z32 Hood Hinge and Covers 3D printing
-
SRH
11:52:21 12/06/20
I'll add that rubber seal to my list.
-
Master_Blaster
12:01:49 12/06/20
Re: I'll add that rubber seal to my list.
-
MyBlueZ
06:41:15 12/07/20
Blaster, please make the rubber seals above and below
-
ForceFedTT
11:49:27 12/08/20
Re: Z32 Hood Hinge and Covers 3D printing
-
OleMissFan
13:54:22 12/06/20
Re: Re: Z32 Hood Hinge and Covers 3D printing
-
WoodmanZ
07:52:21 12/07/20
Re: Re: Re: Z32 Hood Hinge and Covers 3D printing
-
SRH
09:42:09 12/07/20
It's going to be labor intensive to make the parts look good
-
ZXRider
13:30:24 12/07/20
Windshield Cowl Molding
-
Burton(FL)
23:11:47 12/06/20
Re: Z32 Hood Hinge and Covers 3D printing
-
ExtraTitanian
23:49:59 12/07/20
Re: Re: Z32 Hood Hinge and Covers 3D printing
-
SRH
19:38:27 12/08/20
Not necessary in any way?
-
robo (sebring1970)
05:34:42 12/11/20
Re: Not necessary in any way? -
SRH
01:06:58 12/12/20
We're still talking about different pieces,
-
robo (sebring1970)
07:28:03 12/12/20
Post a
Followup
You cannot reply to this message because you are not
logged in
.