TwinTurbo.NET: Nissan 300ZX forum - Re: Re: Z32 Hood Hinge and Covers 3D printing
People Seeking Info
 
   


     
Subject Re: Re: Z32 Hood Hinge and Covers 3D printing
     
Posted by SRH on December 08, 2020 at 7:38 PM
  This message has been viewed 237 times.
     
In Reply To Re: Z32 Hood Hinge and Covers 3D printing posted by ExtraTitanian on December 07, 2020 at 11:49 PM
     
Message Thanks for the reply. That would be awesome if you could experiment at some point. Agreed, they're not structural, or even necessary in any way, so strength is of almost no importance.
I have gotten by for at least 20 years without decent covers. With 3D printing becoming more mainstream, I was just wondering if it might be a decent process for this application.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.