Subject	It's going to be labor intensive to make the parts look good
Posted by	ZXRider on December 07, 2020 at 1:30 PM
	This message has been viewed 262 times.
In Reply To	Re: Re: Re: Z32 Hood Hinge and Covers 3D printing posted by SRH on December 07, 2020 at 09:42 AM
Message	in addition, none of the material will survive the environment. Most automotive/outdoor use plastics will have UV stabilizers to help with sunlight. Would you be able to save a couple of bucks here and there? Sure, but by the time you keep reprinting the part at some point it would've been the same cost to buy the new OEM plastic part. If they were NLA, that's a different story.
Follow Ups	Z32 Hood Hinge and Covers 3D printing - SRH 11:52:21 12/06/20 I'll add that rubber seal to my list. - Master_Blaster 12:01:49 12/06/20 Re: I'll add that rubber seal to my list. - MyBlueZ 06:41:15 12/07/20 Blaster, please make the rubber seals above and below - ForceFedTT 11:49:27 12/08/20 Re: Z32 Hood Hinge and Covers 3D printing - OleMissFan 13:54:22 12/06/20 Re: Re: Z32 Hood Hinge and Covers 3D printing - WoodmanZ 07:52:21 12/07/20 Re: Re: Re: Z32 Hood Hinge and Covers 3D printing - SRH 09:42:09 12/07/20 It's going to be labor intensive to make the parts look good - ZXRider 13:30:24 12/07/20 Windshield Cowl Molding - Burton(FL) 23:11:47 12/06/20 Re: Z32 Hood Hinge and Covers 3D printing - ExtraTitanian 23:49:59 12/07/20 Re: Re: Z32 Hood Hinge and Covers 3D printing - SRH 19:38:27 12/08/20 Not necessary in any way? - robo (sebring1970) 05:34:42 12/11/20 Re: Not necessary in any way? - SRH 01:06:58 12/12/20 We're still talking about different pieces, - robo (sebring1970) 07:28:03 12/12/20
Post a Followup	You cannot reply to this message because you are not logged in.