TwinTurbo.NET: Nissan 300ZX forum - Re: Re: Z32 Hood Hinge and Covers 3D printing
People Seeking Info
 
   


     
Subject Re: Re: Z32 Hood Hinge and Covers 3D printing
     
Posted by WoodmanZ on December 07, 2020 at 7:52 AM
  This message has been viewed 240 times.
     
In Reply To Re: Z32 Hood Hinge and Covers 3D printing posted by OleMissFan on December 06, 2020 at 01:54 PM
     
Message I'm not a plastics engineer or anything, but I think if it was made out of a PA6 or similar material with a 30-40% glass fiber reinforcement if it would be less prone to crack like the OEM stuff--However, that would require a special thermoplastic molding process.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.