Subject	Re: Z32 Hood Hinge and Covers 3D printing
Posted by	OleMissFan on December 06, 2020 at 1:54 PM
	This message has been viewed 308 times.
In Reply To	Z32 Hood Hinge and Covers 3D printing posted by SRH on December 06, 2020 at 11:52 AM
Message	That is one of those special parts.. I am a big fan of remaking many plastic parts that break out of aluminum, but with that part, I am unsure if that would be wise. If it got out of place I wonder if it could damage the actual hood or surrounding parts?
Follow Ups	Z32 Hood Hinge and Covers 3D printing - SRH 11:52:21 12/06/20 I'll add that rubber seal to my list. - Master_Blaster 12:01:49 12/06/20 Re: I'll add that rubber seal to my list. - MyBlueZ 06:41:15 12/07/20 Blaster, please make the rubber seals above and below - ForceFedTT 11:49:27 12/08/20 Re: Z32 Hood Hinge and Covers 3D printing - OleMissFan 13:54:22 12/06/20 Re: Re: Z32 Hood Hinge and Covers 3D printing - WoodmanZ 07:52:21 12/07/20 Re: Re: Re: Z32 Hood Hinge and Covers 3D printing - SRH 09:42:09 12/07/20 It's going to be labor intensive to make the parts look good - ZXRider 13:30:24 12/07/20 Windshield Cowl Molding - Burton(FL) 23:11:47 12/06/20 Re: Z32 Hood Hinge and Covers 3D printing - ExtraTitanian 23:49:59 12/07/20 Re: Re: Z32 Hood Hinge and Covers 3D printing - SRH 19:38:27 12/08/20 Not necessary in any way? - robo (sebring1970) 05:34:42 12/11/20 Re: Not necessary in any way? - SRH 01:06:58 12/12/20 We're still talking about different pieces, - robo (sebring1970) 07:28:03 12/12/20
Post a Followup	You cannot reply to this message because you are not logged in.