TwinTurbo.NET: Nissan 300ZX forum - I'll add that rubber seal to my list.
People Seeking Info
 
   


     
Subject I'll add that rubber seal to my list.
     
Posted by Master_Blaster on December 06, 2020 at 12:01 PM
  This message has been viewed 337 times.
     
In Reply To Z32 Hood Hinge and Covers 3D printing posted by SRH on December 06, 2020 at 11:52 AM
     
Message This summer I started working with my rubber folks to get the rubber seals on the rear of the hood that seal on top of the cowls, the front hood seal, and the rear cowl edge seal into production. I should be releasing these on my Blaster Z page in early 2021.

As for 3d printing the hinge cover, It could be possible if someone utilized the proper material. In my opinion that part should be improved more than it should be replicated.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.