TwinTurbo.NET: Nissan 300ZX forum - Yep, of course.
People Seeking Info
 
   


     
Subject Yep, of course.
     
Posted by Keaner on July 31, 2020 at 10:07 PM
  This message has been viewed 17 times.
     
In Reply To The pitch/module/tooth count are certainly standard posted by black300zx on July 31, 2020 at 03:13 PM
     
Message There are about a dozen standard module specs though, so we'd need to figure out which. But the suggestion was to cast gears out of aluminum, which is actually incredibly difficult to do accurately due to the small figures.

So I suggested that you could buy brass/aluminum ones off the shelf and modify the bores, or even just cut new ones for less unless you had a large enough run.

That said, the 3d printed ones are likely just as good of an idea.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.