TwinTurbo.NET: Nissan 300ZX forum - Re: Interesting, I wonder why KA8 ^^ had a different experience
Subject
Re: Interesting, I wonder why KA8 ^^ had a different experience
Posted by
KA8
on June 29, 2020 at 5:15 PM
This message has been viewed
239
times.
In Reply To
Interesting, I wonder why KA8 ^^ had a different experience
posted by moxie (SF)
on June 29, 2020 at 03:44 PM
Message
Not sure why. Got them at Z1. Looking at pad wear, it almost looked like the brackets themselves had slight tilt on them so pads weren't making good contact. Who knows maybe I got a bad set.
Follow Ups
question for those with 350z rotors with stock calipers
-
moxie (SF)
23:53:06 06/28/20
I ran this setup for a short time on my last Z
-
Ghoztt (MD)
07:14:17 06/29/20
Also using Hawk (HPS+) pads
-
megaDan
08:18:09 06/29/20
yeah the pad overhangs a bit on the top
-
moxie (SF)
12:25:24 06/29/20
What was the reason for removing the 350z calipers to begin
-
Ghoztt (MD)
12:44:42 06/29/20
well, I was going to sell the car
-
moxie (SF)
13:49:48 06/29/20
This is silly logic. Refinished all 4. Install the Brembos (n/m)
-
Bernie (NoVA)
14:03:06 06/29/20
:thumbsup: (n/m)
-
moxie (SF)
15:23:08 06/29/20
I've had this setup for years..
-
Stanky (BC)
16:17:42 06/29/20
^this was meant towards OP, not directly at your post :) (n/m)
-
Stanky (BC)
16:18:51 06/29/20
I was completely stock until I made my Hyundai brembo kit
-
BlackholeZ
10:25:10 06/29/20
I had relocation bracket before upgrading to brembos. In my
-
KA8
12:49:42 06/29/20
thank you, this is all I needed to hear! (n/m)
-
moxie (SF)
13:57:38 06/29/20
I have them with the RP 13" rear kit. I also run Hawk HPS+
-
Red Hawk (CO)
14:18:28 06/29/20
Interesting, I wonder why KA8 ^^ had a different experience
-
moxie (SF)
15:44:04 06/29/20
Re: Interesting, I wonder why KA8 ^^ had a different experience -
KA8
17:15:02 06/29/20
As an added note, different pads made the kit work for me.
-
fantomZ(OH)
15:00:43 06/30/20
Thank you! This looks interesting.
-
moxie (SF)
16:43:51 06/30/20
Here is the comparison
-
itsa300zx
16:48:45 06/30/20
thanks! (n/m)
-
moxie (SF)
17:53:09 06/30/20
How my pads looked with Z1 350z rotor brackets
-
Schmeal (NV)
12:33:11 07/09/20
That is a lot of over hang. IIRC, when I had COZ
-
itsa300zx
19:53:00 07/13/20
Post a
Followup
You cannot reply to this message because you are not
logged in
.