Subject	^this was meant towards OP, not directly at your post :) (n/m)
Posted by	Stanky (BC) on June 29, 2020 at 4:18 PM
	This message has been viewed 202 times.
In Reply To	I've had this setup for years.. posted by Stanky (BC) on June 29, 2020 at 04:17 PM
Message
Follow Ups	question for those with 350z rotors with stock calipers - moxie (SF) 23:53:06 06/28/20 I ran this setup for a short time on my last Z - Ghoztt (MD) 07:14:17 06/29/20 Also using Hawk (HPS+) pads - megaDan 08:18:09 06/29/20 yeah the pad overhangs a bit on the top - moxie (SF) 12:25:24 06/29/20 What was the reason for removing the 350z calipers to begin - Ghoztt (MD) 12:44:42 06/29/20 well, I was going to sell the car - moxie (SF) 13:49:48 06/29/20 This is silly logic. Refinished all 4. Install the Brembos (n/m) - Bernie (NoVA) 14:03:06 06/29/20 :thumbsup: (n/m) - moxie (SF) 15:23:08 06/29/20 I've had this setup for years.. - Stanky (BC) 16:17:42 06/29/20 ^this was meant towards OP, not directly at your post :) (n/m) - Stanky (BC) 16:18:51 06/29/20 I was completely stock until I made my Hyundai brembo kit - BlackholeZ 10:25:10 06/29/20 I had relocation bracket before upgrading to brembos. In my - KA8 12:49:42 06/29/20 thank you, this is all I needed to hear! (n/m) - moxie (SF) 13:57:38 06/29/20 I have them with the RP 13" rear kit. I also run Hawk HPS+ - Red Hawk (CO) 14:18:28 06/29/20 Interesting, I wonder why KA8 ^^ had a different experience - moxie (SF) 15:44:04 06/29/20 Re: Interesting, I wonder why KA8 ^^ had a different experience - KA8 17:15:02 06/29/20 As an added note, different pads made the kit work for me. - fantomZ(OH) 15:00:43 06/30/20 Thank you! This looks interesting. - moxie (SF) 16:43:51 06/30/20 Here is the comparison - itsa300zx 16:48:45 06/30/20 thanks! (n/m) - moxie (SF) 17:53:09 06/30/20 How my pads looked with Z1 350z rotor brackets - Schmeal (NV) 12:33:11 07/09/20 That is a lot of over hang. IIRC, when I had COZ - itsa300zx 19:53:00 07/13/20
Post a Followup	You cannot reply to this message because you are not logged in.