TwinTurbo.NET: Nissan 300ZX forum - I had relocation bracket before upgrading to brembos. In my
Subject
I had relocation bracket before upgrading to brembos. In my
Posted by
KA8
on June 29, 2020 at 12:49 PM
This message has been viewed
330
times.
In Reply To
question for those with 350z rotors with stock calipers
posted by moxie (SF)
on June 28, 2020 at 11:53 PM
Message
experience the fade will never go away and brakes will only sometimes feel confident even with Hawk pads. You should go back to brembos. Why did you downgrade? I can't seem to understand the reasoning
Follow Ups
question for those with 350z rotors with stock calipers
-
moxie (SF)
23:53:06 06/28/20
I ran this setup for a short time on my last Z
-
Ghoztt (MD)
07:14:17 06/29/20
Also using Hawk (HPS+) pads
-
megaDan
08:18:09 06/29/20
yeah the pad overhangs a bit on the top
-
moxie (SF)
12:25:24 06/29/20
What was the reason for removing the 350z calipers to begin
-
Ghoztt (MD)
12:44:42 06/29/20
well, I was going to sell the car
-
moxie (SF)
13:49:48 06/29/20
This is silly logic. Refinished all 4. Install the Brembos (n/m)
-
Bernie (NoVA)
14:03:06 06/29/20
:thumbsup: (n/m)
-
moxie (SF)
15:23:08 06/29/20
I've had this setup for years..
-
Stanky (BC)
16:17:42 06/29/20
^this was meant towards OP, not directly at your post :) (n/m)
-
Stanky (BC)
16:18:51 06/29/20
I was completely stock until I made my Hyundai brembo kit
-
BlackholeZ
10:25:10 06/29/20
I had relocation bracket before upgrading to brembos. In my -
KA8
12:49:42 06/29/20
thank you, this is all I needed to hear! (n/m)
-
moxie (SF)
13:57:38 06/29/20
I have them with the RP 13" rear kit. I also run Hawk HPS+
-
Red Hawk (CO)
14:18:28 06/29/20
Interesting, I wonder why KA8 ^^ had a different experience
-
moxie (SF)
15:44:04 06/29/20
Re: Interesting, I wonder why KA8 ^^ had a different experience
-
KA8
17:15:02 06/29/20
As an added note, different pads made the kit work for me.
-
fantomZ(OH)
15:00:43 06/30/20
Thank you! This looks interesting.
-
moxie (SF)
16:43:51 06/30/20
Here is the comparison
-
itsa300zx
16:48:45 06/30/20
thanks! (n/m)
-
moxie (SF)
17:53:09 06/30/20
How my pads looked with Z1 350z rotor brackets
-
Schmeal (NV)
12:33:11 07/09/20
That is a lot of over hang. IIRC, when I had COZ
-
itsa300zx
19:53:00 07/13/20
Post a
Followup
You cannot reply to this message because you are not
logged in
.