Subject	Quik Jack Placement
Posted by	PNW280Z on June 24, 2020 at 9:52 AM
	This message has been viewed 400 times.
Message	I have a quik jack I use for a bunch of other cars, and was looking for advice on if it will work with my Z32. The issue I see is that the two lift points on the Z are not perpendicular to each other. Most cars I set the blocks to lift on the frame rail. Anyone have any experience or insight into how I can make this work with the quik jack? Can it be set at the slight angle that is needed? I would think not but would like the help.
Follow Ups	Quik Jack Placement - PNW280Z 09:52:18 06/24/20 They sell pinch-weld blocks that have worked well for me - jval 13:35:23 06/24/20 Unfortunately I use my quick jack on the Z far too often. - megaDan 15:24:10 06/24/20 Re: Unfortunately I use my quick jack on the Z far too often. - PNW280Z 17:56:49 06/24/20 I’ve only used mine once, I do the same (n/m) - itsa300zx 19:06:20 06/24/20 I have been using the pinch weld to lift for a few years - Gordo LSZ Daytona 19:27:02 06/24/20 Photos look deceiving....? - FrozTTy 18:52:39 06/25/20 The rubber is compressed by the pinch weld. - Gordo LSZ Daytona 20:19:12 06/25/20 Which model quick jack do you have? (n/m) - ctheobal 23:23:40 06/26/20 Which model quick jack do you have? (n/m) - ctheobal 14:24:55 07/04/20 Which model quick jack do you have? (n/m) - ctheobal 18:56:54 08/01/20 You can also try placing your QuickJack's Sideways - slick666 10:04:06 06/30/20
Post a Followup	You cannot reply to this message because you are not logged in.