TwinTurbo.NET: Nissan 300ZX forum - Re: Important note about powdercoating....
Subject
Re: Important note about powdercoating....
Posted by
ouikikazz
on May 20, 2020 at 12:52 PM
This message has been viewed
213
times.
In Reply To
Important note about powdercoating....
posted by black300zx
on May 20, 2020 at 07:09 AM
Message
i believe viton was the preferred oring material when I did mine years ago mcmaster carrys a ton of different orings
Follow Ups
Caliper Refinishing Suggestions
-
fuzzymonkey
13:45:17 05/19/20
must... resist....shaving...monkey
-
vorpalZed
18:13:53 05/19/20
Pardon? (n/m)
-
ConVerTT
19:45:06 05/19/20
Important note about powdercoating....
-
black300zx
07:09:01 05/20/20
Re: Important note about powdercoating.... -
ouikikazz
12:52:42 05/20/20
The half seals come in the Centric rebuild kit
-
nissubaru
08:36:55 05/21/20
Nice! I don't think those were available (or known to exist)
-
black300zx
06:32:38 05/22/20
8.5/10, would giggle again (n/m)
-
Zeus
14:21:42 05/20/20
RoRo Designs is in Ontario - not exactly close, but at least
-
J-Mart
18:41:31 05/19/20
Simple Green did the same thing to my StopTech calipers
-
LitlElvis
12:22:00 05/20/20
Simple Green was what I used to remove the hazy discolouring
-
fuzzymonkey
20:27:10 05/20/20
Post a
Followup
You cannot reply to this message because you are not
logged in
.