Subject	It had a few issues.
Posted by	Bernie (NoVA) on January 15, 2020 at 1:09 AM
	This message has been viewed 253 times.
In Reply To	Bernie, what exatly causes it to loosen / slip? posted by Jkova300z on January 14, 2020 at 08:35 PM
Message	One of the little set screws was missing I think so the whole assembly would rotate, but also it made the car handle weird, as it would make one arm longer vs the other wise. I didn't care for it for a few reasons. The factory assumes that the lower arm is a certain size, all the other readings depend on that constant, once you turn the cam bolt on this, it takes all the settings which are ties to this arm out of spec with it and you have to start all over again. Also its a permanent mod to the cross member, you have to cut out the holes on the cross member and you are stuck with it. If you drill out a little off center, oh well now its not symmetric, if you change your mind, now you need a new cross member, if you hit a bump it would slip. Bernie Bilski berniebilski@cox.net President of Z-Car Club of Northern Virginia 1995 Nissan 300ZX TwinTurbo in Cobalt Green 1997 Nissan 240SX SE in Ultra Red 2006 Nissan Frontier SE in Ultra Black
Follow Ups	95 TT. Front lower control arm connection to the chassis - dancefloor 22:09:00 01/09/20 I pulled a Engine from a '90 NA, Had the same thing (n/m) - Cjw3 06:53:35 01/10/20 Zspeed Performance (link inside) - RonZ300 (Socal) 08:58:23 01/10/20 How is this supposed to work? Wouldn't the upper arm max out - nissubaru 10:24:17 01/10/20 Adjusting the length of the Upper Control Arm to - JMartz 14:23:37 01/10/20 I've seen this before too. It's not stock. It doesn't work. - Bernie (NoVA) 16:13:40 01/10/20 I have one spare 95 NA crossmember, does it fit? (n/m) - dancefloor 19:47:43 01/10/20 Yes it will work - it will lack the small mounting tab for - Bernie (NoVA) 14:50:43 01/11/20 You should also have a pair of engine mounts on hand. - Bernie (NoVA) 14:51:48 01/11/20 do I just use 2x stands to support the engine/gearbox area - dancefloor 18:34:33 01/11/20 I use a hoist from above plus support on the trans. - Bernie (NoVA) 04:26:19 01/12/20 I use something like this - Cjw3 19:18:00 01/12/20 <like> Re: I use something like this (n/m) - dancefloor 20:46:19 01/12/20 Bernie, what exatly causes it to loosen / slip? - Jkova300z 20:35:45 01/14/20 It had a few issues. - Bernie (NoVA) 01:09:24 01/15/20
Post a Followup	You cannot reply to this message because you are not logged in.