Subject	You should also have a pair of engine mounts on hand.
Posted by	Bernie (NoVA) on January 11, 2020 at 2:51 PM
	This message has been viewed 308 times.
In Reply To	Yes it will work - it will lack the small mounting tab for posted by Bernie (NoVA) on January 11, 2020 at 02:50 PM
Message	Odds are you will want to replace them if the crossmember is removed. Bernie Bilski berniebilski@cox.net President of Z-Car Club of Northern Virginia 1995 Nissan 300ZX TwinTurbo in Cobalt Green 1997 Nissan 240SX SE in Ultra Red 2006 Nissan Frontier SE in Ultra Black
Follow Ups	95 TT. Front lower control arm connection to the chassis - dancefloor 22:09:00 01/09/20 I pulled a Engine from a '90 NA, Had the same thing (n/m) - Cjw3 06:53:35 01/10/20 Zspeed Performance (link inside) - RonZ300 (Socal) 08:58:23 01/10/20 How is this supposed to work? Wouldn't the upper arm max out - nissubaru 10:24:17 01/10/20 Adjusting the length of the Upper Control Arm to - JMartz 14:23:37 01/10/20 I've seen this before too. It's not stock. It doesn't work. - Bernie (NoVA) 16:13:40 01/10/20 I have one spare 95 NA crossmember, does it fit? (n/m) - dancefloor 19:47:43 01/10/20 Yes it will work - it will lack the small mounting tab for - Bernie (NoVA) 14:50:43 01/11/20 You should also have a pair of engine mounts on hand. - Bernie (NoVA) 14:51:48 01/11/20 do I just use 2x stands to support the engine/gearbox area - dancefloor 18:34:33 01/11/20 I use a hoist from above plus support on the trans. - Bernie (NoVA) 04:26:19 01/12/20 I use something like this - Cjw3 19:18:00 01/12/20 <like> Re: I use something like this (n/m) - dancefloor 20:46:19 01/12/20 Bernie, what exatly causes it to loosen / slip? - Jkova300z 20:35:45 01/14/20 It had a few issues. - Bernie (NoVA) 01:09:24 01/15/20
Post a Followup	You cannot reply to this message because you are not logged in.