Subject	I have one spare 95 NA crossmember, does it fit? (n/m)
Posted by	dancefloor on January 10, 2020 at 7:47 PM
	This message has been viewed 317 times.
In Reply To	I've seen this before too. It's not stock. It doesn't work. posted by Bernie (NoVA) on January 10, 2020 at 04:13 PM
Message
Follow Ups	95 TT. Front lower control arm connection to the chassis - dancefloor 22:09:00 01/09/20 I pulled a Engine from a '90 NA, Had the same thing (n/m) - Cjw3 06:53:35 01/10/20 Zspeed Performance (link inside) - RonZ300 (Socal) 08:58:23 01/10/20 How is this supposed to work? Wouldn't the upper arm max out - nissubaru 10:24:17 01/10/20 Adjusting the length of the Upper Control Arm to - JMartz 14:23:37 01/10/20 I've seen this before too. It's not stock. It doesn't work. - Bernie (NoVA) 16:13:40 01/10/20 I have one spare 95 NA crossmember, does it fit? (n/m) - dancefloor 19:47:43 01/10/20 Yes it will work - it will lack the small mounting tab for - Bernie (NoVA) 14:50:43 01/11/20 You should also have a pair of engine mounts on hand. - Bernie (NoVA) 14:51:48 01/11/20 do I just use 2x stands to support the engine/gearbox area - dancefloor 18:34:33 01/11/20 I use a hoist from above plus support on the trans. - Bernie (NoVA) 04:26:19 01/12/20 I use something like this - Cjw3 19:18:00 01/12/20 <like> Re: I use something like this (n/m) - dancefloor 20:46:19 01/12/20 Bernie, what exatly causes it to loosen / slip? - Jkova300z 20:35:45 01/14/20 It had a few issues. - Bernie (NoVA) 01:09:24 01/15/20
Post a Followup	You cannot reply to this message because you are not logged in.