Subject	Air intake filter setup options
Posted by	dTb on December 14, 2019 at 6:17 PM
	This message has been viewed 499 times.
Message	Hi all, Looking for opinions/ideas on air intake setups. My current setup is using 2X JWT pop chargers with 2X MAF delete adapters (I'm on a map setup), and AshSpecs 2.5 intake pipe kit.. I tore one of the filters and I don't like the setup so I'm looking to change. I don't like how much space my current setup takes, I need to free up some room to properly mount my oil cooler, and I don't need the Venturi velocity stacks used on these filters because no MAF... So, I am looking for ideas on what people have done to adapt low profile high flow filters (which ones?) directly as possible to the intake pipes. I found a cylindrical filter with two ends open that might work but not sure where to find adapters. I've also been eyeing the HKS mushroom looking filters but also would need to hunt around for adapters. There doesn't seem to be allot of pnp kits out there for this piping set. Thoughts?
Follow Ups	Air intake filter setup options - dTb 18:17:14 12/14/19 JWT 370z filters are smaller. i use two of those. (n/m) - slayer fan 19:59:16 12/14/19 Thank you.. do these filters use the same Venturi plates - dTb 21:25:13 12/14/19 i use a Selin maf translator. i bought the complete - slayer fan 21:40:00 12/14/19 now that i think about it, the kit i bought came - slayer fan 22:13:11 12/14/19 They do fit the venturi base plate. (n/m) - MixManMash 13:33:16 12/16/19 Yes (n/m) - Bernie (NoVA) 22:24:40 12/14/19 I use two Apexi cone filters :-/ (n/m) - ForceFedTT 22:28:27 12/14/19 Apexi filters and 370Z filters will do the trick - RobZ32 09:17:02 12/16/19 My setup (370z cones with Selin translator & bracket kit) - Zeus 12:51:35 12/16/19 I have dual K&N RB-0700 filters - Jehannum 14:33:43 12/17/19
Post a Followup	You cannot reply to this message because you are not logged in.