Subject	Re: Rod to Crank Side to side clearance.
Posted by	CmyZ on December 08, 2019 at 9:27 PM
	This message has been viewed 290 times.
In Reply To	Rod to Crank Side to side clearance. posted by nonstopna on December 08, 2019 at 06:44 PM
Message	The Factory cranks do have drilled holes on the counterweights. Start by measuring the Crankshaft end play. If that's in tolerance then proceed to check the rod clearance Crankshaft End play - Std. 0.05 - 0.18 MM or 0.0020 - 0.0071 in . Limit 0.30 MM or 0.0118 in Connecting Rod clearance Standard its .20 to .35 MM or 0.00790- 0.00138 in. Max Limit - .40 MM or 0.0157 inch. Hope that helps.
Follow Ups	Rod to Crank Side to side clearance. - nonstopna 18:44:58 12/08/19 Pic didn't show up...you'll have to copy and paste maybe - nonstopna 18:50:28 12/08/19 Re: Rod to Crank Side to side clearance. - CmyZ 21:27:01 12/08/19 Re: Re: Rod to Crank Side to side clearance. - nonstopna 10:24:06 12/10/19
Post a Followup	You cannot reply to this message because you are not logged in.