TwinTurbo.NET: Nissan 300ZX forum - Rod to Crank Side to side clearance.
People Seeking Info

Subject Rod to Crank Side to side clearance.
Posted by nonstopna on December 08, 2019 at 6:44 PM
  This message has been viewed 79 times.
Message Anybody happen to know how much clearance there is suppose to be in between the rod and crank? I don't know if this engine had new pistons/rods replaced. I see the crank was drilled on a few places to get balanced but is that how they come from factory?

Follow Ups  
Post a

You cannot reply to this message because you are not logged in.