Subject	Also, replace the Phillips Head screws with Allen Heads
Posted by	Barry (NJ) on December 04, 2019 at 11:23 AM
	This message has been viewed 289 times.
In Reply To	Spring Clamp Position posted by RAD1 on December 04, 2019 at 11:02 AM
Message	Much easier to tighten securely.
Follow Ups	Finally getting some work in - new style injector swap - Woodnutz 07:15:54 12/04/19 Again, thanks Bernie for putting together the drop-in kit! (n/m) - Woodnutz 07:20:05 12/04/19 No spring fuel clamps for those two hard to reach screws? (n/m) - itsa300zx 09:44:43 12/04/19 I know, I know... I'll be kicking myself later for that one (n/m) - Woodnutz 10:14:17 12/04/19 Spring Clamp Position - RAD1 11:02:11 12/04/19 Also, replace the Phillips Head screws with Allen Heads - Barry (NJ) 11:23:52 12/04/19 Thanks for the tips, guys! Plenum is back on, still have - Woodnutz 23:31:46 12/04/19 Make sure your also do the 12v switch mod. - Bernie (NoVA) 07:36:42 12/05/19 Yea, the genius move I pulled so far is clearance-ing the - Woodnutz 08:23:05 12/05/19 Looking good. (n/m) - Bernie (NoVA) 07:35:04 12/05/19
Post a Followup	You cannot reply to this message because you are not logged in.