TwinTurbo.NET: Nissan 300ZX forum - Spring Clamp Position
Subject
Spring Clamp Position
Posted by
RAD1
on December 04, 2019 at 11:02 AM
This message has been viewed
272
times.
In Reply To
I know, I know... I'll be kicking myself later for that one (n/m)
posted by Woodnutz
on December 04, 2019 at 10:14 AM
Message
For the driver side, try to set the clamp such that the screw is horizontal for adjusting from the front. For the passenger side, tilt the screw slightly towards the back for easier adjustment from above.
Follow Ups
Finally getting some work in - new style injector swap
-
Woodnutz
07:15:54 12/04/19
Again, thanks Bernie for putting together the drop-in kit! (n/m)
-
Woodnutz
07:20:05 12/04/19
No spring fuel clamps for those two hard to reach screws? (n/m)
-
itsa300zx
09:44:43 12/04/19
I know, I know... I'll be kicking myself later for that one (n/m)
-
Woodnutz
10:14:17 12/04/19
Spring Clamp Position -
RAD1
11:02:11 12/04/19
Also, replace the Phillips Head screws with Allen Heads
-
Barry (NJ)
11:23:52 12/04/19
Thanks for the tips, guys! Plenum is back on, still have
-
Woodnutz
23:31:46 12/04/19
Make sure your also do the 12v switch mod.
-
Bernie (NoVA)
07:36:42 12/05/19
Yea, the genius move I pulled so far is clearance-ing the
-
Woodnutz
08:23:05 12/05/19
Looking good. (n/m)
-
Bernie (NoVA)
07:35:04 12/05/19
Post a
Followup
You cannot reply to this message because you are not
logged in
.