TwinTurbo.NET: Nissan 300ZX forum - Um, pretty sure heat is the biggest problem.
People Seeking Info
 
   


     
Subject Um, pretty sure heat is the biggest problem.
     
Posted by ni[x]it on August 19, 2019 at 7:08 AM
  This message has been viewed 15 times.
     
In Reply To 3d Printed manifolds are getting common in FSAE posted by BlackholeZ on August 07, 2019 at 11:50 PM
     
Message I've printed a few Z related interior parts out of ABS plastic.
In the Texas heat, they all got soft, warped and looked
'amateur'.
Right off the printer, sure, everything looks great, but put
into application, the parts are likely to fail. Way way more
some in the engine compartment.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.