Subject	Hydraulics
Posted by	ZXoltan on July 23, 2019 at 7:50 AM
	This message has been viewed 313 times.
In Reply To	The clutch pedal doesn't have any pressure... posted by RUZH on July 22, 2019 at 11:59 PM
Message	If the pedal just goes to the floor and happened suddenly then it is hydraulic failure. If you have fluid on the floor under the transmission its the slave. The master may or may not show fluid on the carpet by the pedal area (may be under the carpet or just hard to see).
Follow Ups	Need a flywheel and clutch kit - amezcuaz32 19:57:32 07/17/19 Advice: - CameronSF 20:08:34 07/17/19 Re: Need a flywheel and clutch kit - itsa300zx 20:25:37 07/17/19 $250 cdn. For the kit so well within your budget. (n/m) - itsa300zx 22:22:27 07/17/19 Re: Need a flywheel and clutch kit - Metacom 21:20:58 07/17/19 Contact joe @ ZSPEED - Drk93TT 06:14:36 07/19/19 Me too... clutch died on me today! - RUZH 14:49:41 07/20/19 Was the clutch pedal adjusted properly? - MixManMash 07:57:32 07/22/19 The clutch pedal doesn't have any pressure... - RUZH 23:59:38 07/22/19 Hydraulics - ZXoltan 07:50:40 07/23/19 Unless the internal seals have failed, in which case you - MixManMash 19:09:58 07/23/19 I couldn't see any leaked fluids from the clutch cylinders - RUZH 13:42:13 07/24/19 The new SZ pressure plates are designed differently from - MixManMash 19:09:19 07/23/19 I wasn't very happy with the RPS 6 puck - RUZH 13:50:35 07/24/19 I agree. I have driven a Z32 with that same clutch. It's - MixManMash 20:59:28 07/24/19
Post a Followup	You cannot reply to this message because you are not logged in.