Subject	?
Posted by	Mike (NoVA) on April 27, 2019 at 11:23 PM
	This message has been viewed 334 times.
In Reply To	If these were on Santa's sleigh... maybe. posted by Gordo NA2LS Daytona on April 27, 2019 at 04:28 PM
Message
Follow Ups	Tien Lowering Spring Length vs. OEM NA - Gordo NA2LS Daytona 20:27:25 04/23/19 Good info Gordo. Curious to see results. (n/m) - CameronSF 08:53:58 04/24/19 I'm concerned that playing mix & match w springs for "look" - Bernie (NoVA) 09:01:10 04/24/19 Agreed. (n/m) - MixManMash 19:10:29 04/24/19 Are both of the Tein springs progressive? (n/m) - Tanley (ATL) 09:18:33 04/24/19 The winding looks linear to me, they are equally spaced (n/m) - Bernie (NoVA) 09:42:48 04/24/19 Looks to be linear to me as well. (n/m) - Ghoztt 10:20:52 04/24/19 Example - Bernie (NoVA) 09:45:43 04/24/19 Tien website says both S and H series are progressive. - Gordo NA2LS Daytona 12:06:53 04/24/19 I think it depends on the application. Their Z32 ones look - Bernie (NoVA) 23:23:34 04/24/19 Are you doing this just for visual reference? - Ghoztt 10:29:16 04/24/19 Yes. Just a visual reference. Will only use matched set. (n/m) - Gordo NA2LS Daytona 11:56:48 04/24/19 Thanks for the visual! I've looked at the S-techs as a... - Woodnutz 11:34:56 04/24/19 Let me be clear. All four springs will be of the same set. - Gordo NA2LS Daytona 11:50:26 04/24/19 New twist to the project... or should I say 'bend' - Gordo NA2LS Daytona 16:21:44 04/24/19 Yeah that is definitely ng (n/m) - Boosted1 18:27:43 04/24/19 I wouldn't be surprised if that caused some of the front end - MixManMash 19:13:22 04/24/19 I thought about that. Without the springs, I could fully - Gordo NA2LS Daytona 20:06:23 04/24/19 In stock... :-/ (n/m) - Bernie (NoVA) 23:26:24 04/24/19 time to lay off the bacon cheeseburgers! (n/m) - LJZTT 16:48:02 04/25/19 If these were on Santa's sleigh... maybe. - Gordo NA2LS Daytona 16:28:46 04/27/19 ? - Mike (NoVA) 23:23:38 04/27/19
Post a Followup	You cannot reply to this message because you are not logged in.