Subject	I went with generic ceramic coating inside and out.
Posted by	ni[x]it on April 14, 2019 at 10:09 AM
	This message has been viewed 308 times.
In Reply To	What is the concensus on thermo-coating iron manifolds? posted by ZXoltan on April 12, 2019 at 12:08 PM
Message	I did not make this decision based on anything scientific or race proven. Just hoping the heat rejection will increase longevity. My build is based on headroom. Build a 600hp motor, but run it at 400hp. I haven't raced for The Cup since Mario Cart.
Follow Ups	What is the concensus on thermo-coating iron manifolds? - ZXoltan 12:08:08 04/12/19 Re: What is the concensus on thermo-coating iron manifolds? - OleMissFan 16:27:47 04/12/19 That was related to the inconel manifolds that they used to - MixManMash 17:38:52 04/12/19 My opinion. Take it for what it's worth. - MixManMash 17:50:43 04/12/19 My turbine housings and MSP manis are generic ceramic coated (n/m) - Yeehaw 02:44:07 04/13/19 So maybe the real question becomes which coating to use? - ZXoltan 07:14:46 04/13/19 How hot do the TT manifolds typically get? - ZXoltan 08:05:25 04/13/19 Things have changed since ceramics were introduced - shaggee 08:14:25 04/15/19 2nd - vorpalZed 09:30:26 04/15/19 I went with generic ceramic coating inside and out. - ni[x]it 10:09:06 04/14/19 Re: What is the concensus on thermo-coating iron manifolds? - ouikikazz 11:50:32 04/15/19 Folks have said it burns right off, but thanks! - ZXoltan 12:53:45 04/15/19
Post a Followup	You cannot reply to this message because you are not logged in.