Subject	Re: See below...
Posted by	Guyver1 on March 16, 2019 at 3:05 PM
	This message has been viewed 219 times.
In Reply To	See below... posted by DVDBURN (MD) on March 14, 2019 at 02:13 AM
Message	i swapped the coil pin but the 3v doesn't disappear, now the car try to start but do more flame under the exhaust and it doesn't run. i did more test, and last i think is definitive ... i connect just positive and negative and i see 5v on pin 30 (sensor ground) and 5v on pin 38 (TPS signal) i think there's some wrong on the ecu
Follow Ups	Problem with AEM EMS V2 on my95 - Guyver1 00:56:24 03/12/19 Sounds like the extension patch has a few wires mixed up - LitlElvis 01:53:40 03/12/19 Re: Sounds like the extension patch has a few wires mixed up - Guyver1 02:07:16 03/12/19 Are you using the extension patch also with the stock ECU? (n/m) - LitlElvis 02:21:29 03/12/19 Re: Are you using the extension patch also with the stock ECU? - Guyver1 02:32:35 03/12/19 Ooops, I see that you connected the AEM to the stock harness - LitlElvis 02:36:29 03/12/19 Re: Ooops, I see that you connected the AEM to the stock harness - Guyver1 02:38:53 03/12/19 Do you have the instructions? download for PN: 30-6620 - LitlElvis 02:49:12 03/12/19 Re: Do you have the instructions? download for PN: 30-6620 - Guyver1 02:57:38 03/12/19 See below... - DVDBURN (MD) 02:13:49 03/14/19 Re: See below... - Guyver1 15:05:37 03/16/19 Re: Problem with AEM EMS V2 on my95 - Guyver1 02:43:08 03/14/19 you shouldn't measure any voltage at pin 30 it's a ground, - LitlElvis 11:59:12 03/14/19 used (n/m) - Guyver1 15:06:46 03/16/19
Post a Followup	You cannot reply to this message because you are not logged in.