TwinTurbo.NET: Nissan 300ZX forum - you shouldn't measure any voltage at pin 30 it's a ground,
Subject
you shouldn't measure any voltage at pin 30 it's a ground,
Posted by
LitlElvis
on March 14, 2019 at 11:59 AM
This message has been viewed
258
times.
In Reply To
Re: Problem with AEM EMS V2 on my95
posted by Guyver1
on March 14, 2019 at 02:43 AM
Message
If your stock ECU doesn't have voltage at pin 30 but the AEM does, there must be an internal short circuit in the AEM that is energizing pin 30.
Did you buy the AEM new or used?
Follow Ups
Problem with AEM EMS V2 on my95
-
Guyver1
00:56:24 03/12/19
Sounds like the extension patch has a few wires mixed up
-
LitlElvis
01:53:40 03/12/19
Re: Sounds like the extension patch has a few wires mixed up
-
Guyver1
02:07:16 03/12/19
Are you using the extension patch also with the stock ECU? (n/m)
-
LitlElvis
02:21:29 03/12/19
Re: Are you using the extension patch also with the stock ECU?
-
Guyver1
02:32:35 03/12/19
Ooops, I see that you connected the AEM to the stock harness
-
LitlElvis
02:36:29 03/12/19
Re: Ooops, I see that you connected the AEM to the stock harness
-
Guyver1
02:38:53 03/12/19
Do you have the instructions? download for PN: 30-6620
-
LitlElvis
02:49:12 03/12/19
Re: Do you have the instructions? download for PN: 30-6620
-
Guyver1
02:57:38 03/12/19
See below...
-
DVDBURN (MD)
02:13:49 03/14/19
Re: See below...
-
Guyver1
15:05:37 03/16/19
Re: Problem with AEM EMS V2 on my95
-
Guyver1
02:43:08 03/14/19
you shouldn't measure any voltage at pin 30 it's a ground, -
LitlElvis
11:59:12 03/14/19
used (n/m)
-
Guyver1
15:06:46 03/16/19
Post a
Followup
You cannot reply to this message because you are not
logged in
.