Subject	Re: Problem with AEM EMS V2 on my95
Posted by	Guyver1 on March 14, 2019 at 2:43 AM
	This message has been viewed 262 times.
In Reply To	Problem with AEM EMS V2 on my95 posted by Guyver1 on March 12, 2019 at 12:56 AM
Message	yesterday a do this test Disconnect collant temperature sensor, boost sensor, TPS, Fuel temperature sensor, and all AEM sensors but noting change Cut the 35 wire notting change Test with voltmeter the pin 30 e I found 5V Cut the 30 wire and connect directly to the battery, now all sensor read correctly except the TPS, it’s read 3.2V Test with voltmetro the pin 30 directly from ECU and I see 3.2V i think the problem is near ear but i don't understand where
Follow Ups	Problem with AEM EMS V2 on my95 - Guyver1 00:56:24 03/12/19 Sounds like the extension patch has a few wires mixed up - LitlElvis 01:53:40 03/12/19 Re: Sounds like the extension patch has a few wires mixed up - Guyver1 02:07:16 03/12/19 Are you using the extension patch also with the stock ECU? (n/m) - LitlElvis 02:21:29 03/12/19 Re: Are you using the extension patch also with the stock ECU? - Guyver1 02:32:35 03/12/19 Ooops, I see that you connected the AEM to the stock harness - LitlElvis 02:36:29 03/12/19 Re: Ooops, I see that you connected the AEM to the stock harness - Guyver1 02:38:53 03/12/19 Do you have the instructions? download for PN: 30-6620 - LitlElvis 02:49:12 03/12/19 Re: Do you have the instructions? download for PN: 30-6620 - Guyver1 02:57:38 03/12/19 See below... - DVDBURN (MD) 02:13:49 03/14/19 Re: See below... - Guyver1 15:05:37 03/16/19 Re: Problem with AEM EMS V2 on my95 - Guyver1 02:43:08 03/14/19 you shouldn't measure any voltage at pin 30 it's a ground, - LitlElvis 11:59:12 03/14/19 used (n/m) - Guyver1 15:06:46 03/16/19
Post a Followup	You cannot reply to this message because you are not logged in.