TwinTurbo.NET: Nissan 300ZX forum - Do you have the instructions? download for PN: 30-6620
Subject
Do you have the instructions? download for PN: 30-6620
Posted by
LitlElvis
on March 12, 2019 at 2:49 AM
This message has been viewed
251
times.
In Reply To
Re: Ooops, I see that you connected the AEM to the stock harness
posted by Guyver1
on March 12, 2019 at 02:38 AM
Message
and it mentions towards the bottom some of the pinout differences between v1 and v2. Other than that, I'm out of ideas.
Follow Ups
Problem with AEM EMS V2 on my95
-
Guyver1
00:56:24 03/12/19
Sounds like the extension patch has a few wires mixed up
-
LitlElvis
01:53:40 03/12/19
Re: Sounds like the extension patch has a few wires mixed up
-
Guyver1
02:07:16 03/12/19
Are you using the extension patch also with the stock ECU? (n/m)
-
LitlElvis
02:21:29 03/12/19
Re: Are you using the extension patch also with the stock ECU?
-
Guyver1
02:32:35 03/12/19
Ooops, I see that you connected the AEM to the stock harness
-
LitlElvis
02:36:29 03/12/19
Re: Ooops, I see that you connected the AEM to the stock harness
-
Guyver1
02:38:53 03/12/19
Do you have the instructions? download for PN: 30-6620 -
LitlElvis
02:49:12 03/12/19
Re: Do you have the instructions? download for PN: 30-6620
-
Guyver1
02:57:38 03/12/19
See below...
-
DVDBURN (MD)
02:13:49 03/14/19
Re: See below...
-
Guyver1
15:05:37 03/16/19
Re: Problem with AEM EMS V2 on my95
-
Guyver1
02:43:08 03/14/19
you shouldn't measure any voltage at pin 30 it's a ground,
-
LitlElvis
11:59:12 03/14/19
used (n/m)
-
Guyver1
15:06:46 03/16/19
Post a
Followup
You cannot reply to this message because you are not
logged in
.