TwinTurbo.NET: Nissan 300ZX forum - Are you saying the outer machined edge is supposed to be
People Seeking Info
 
   


     
Subject Are you saying the outer machined edge is supposed to be
     
Posted by SirpriZ on February 07, 2019 at 6:02 PM
  This message has been viewed 281 times.
     
In Reply To The pressure plate casing is bolted 0.008" lower not higher posted by itsa300zx on February 07, 2019 at 05:34 PM
     
Message cut .008" lower than the center portion? I think the problem I'm having is I bought a used flywheel where the outer edge (the step I'm referring to) is .008" higher than the center section (where the friction disk contacts the flywheel). So is the outer edge supposed to be machined .008" lower than the center? That makes sense to me in regards to your explanation regarding pre-load. Thanks for hanging in there.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.