Subject	The pressure plate casing is bolted 0.008" lower not higher
Posted by	itsa300zx on February 07, 2019 at 5:34 PM
	This message has been viewed 297 times.
In Reply To	I'm having trouble "seeing" what you are describing though posted by SirpriZ on February 07, 2019 at 05:25 PM
Message	than the friction disc. The up step gives you more pre load on the pressure plate.
Follow Ups	Step on flywheel. I am getting a stock flywheel lightened - SirpriZ 16:25:19 02/07/19 0.008-0.010" is the step height, It does the opposite - itsa300zx 17:05:12 02/07/19 I'm having trouble "seeing" what you are describing though - SirpriZ 17:25:18 02/07/19 The pressure plate casing is bolted 0.008" lower not higher - itsa300zx 17:34:29 02/07/19 Are you saying the outer machined edge is supposed to be - SirpriZ 18:02:56 02/07/19 Correct. Your used flywheel is machined wrong - itsa300zx 18:42:00 02/07/19 I got it. Called shop and had them cut outer - SirpriZ 19:28:25 02/07/19 Outside down. - Bernie (NoVA) 10:13:40 02/08/19 Thanks Bernie. (n/m) - SirpriZ 13:30:15 02/08/19 Is this necesary for a non-OEM clutch as well? - Mr.Stacy 13:36:11 02/08/19 it's optional (n/m) - Bernie (NoVA) 17:42:02 02/08/19 but FWIW the RPS, Fidanza, JWT flywheels all come stepped (n/m) - Bernie (NoVA) 16:27:07 02/11/19
Post a Followup	You cannot reply to this message because you are not logged in.