Subject	The STI brembo rears bolt on - no welding needed. (n/m)
Posted by	Bernie (NoVA) on January 16, 2019 at 7:49 AM
	This message has been viewed 234 times.
In Reply To	Where you the one that welded the rear brake mounting bracke posted by moxie (SF) on January 10, 2019 at 09:25 AM
Message
Follow Ups	Does anyone know what the name of the big round gasket - Musashi Sword 10:48:45 01/09/19 it's a seal (n/m) - LitlElvis 13:27:21 01/09/19 The big round seal then. (n/m) - Musashi Sword 14:11:20 01/09/19 Bingo! (n/m) - LitlElvis 23:33:05 01/10/19 :) (n/m) - Musashi Sword 09:16:52 01/11/19 Check here - Polish 13:30:54 01/09/19 That's it. Rear hub, grease seal. Thanks! (n/m) - Musashi Sword 14:05:34 01/09/19 Where you the one that welded the rear brake mounting bracke - moxie (SF) 09:25:01 01/10/19 It's cast aluminum so I didn't do it. This is the second - Musashi Sword 10:37:57 01/10/19 Did you take the rear hub off or take the whole car someplac (n/m) - moxie (SF) 10:49:05 01/10/19 I got a spare set from Tim so I could do the swap at one - Musashi Sword 11:04:26 01/10/19 How much did the welding cost? And how much of a pita is it - moxie (SF) 16:00:06 01/10/19 On my blue TT it was done while the whole rear end was - Musashi Sword 09:16:32 01/11/19 Here it is with the rotor in place. - Musashi Sword 10:41:32 01/10/19 The STI brembo rears bolt on - no welding needed. (n/m) - Bernie (NoVA) 07:49:30 01/16/19 Jerry. (n/m) - Bernie (NoVA) 14:20:28 01/12/19 Can it be Tom? (n/m) - Musashi Sword 06:24:44 01/14/19
Post a Followup	You cannot reply to this message because you are not logged in.